I speculate that this provides less overhead when converting coordinates into steps but not sure. So you can experiment with these settings. Set the Grid settings to mm/minįor some reason, setting the grid settings from mm/s to mm/min gives a better performance. Note: pictures of LightBurn interface are old and might differ in the more up to date versions. Even the other profiles seem to work well. You can choose Gerbil or Grbl-M3 (uses just easy Gcode). The connection device you choose in new device is not critical. This article describes how to configure LightBurn to get optimum results. There are some settings in LightBurn that you might want to tweak in order to get the best out of both.
0 Comments
Leave a Reply. |